DAC/DAC 8-Bit µP Compatible, Double-Buffered D to A Converters. General Description. The DAC is an advanced CMOS/Si-Cr 8-bit multiplying . As the name itself points out ‘DAC’ is a DAC chip or Digital to Analog Conversion IC. The device is from DAC series that are 8-bit. DAC/DAC 8-Bit μP Compatible, Double-Buffered D to A Converter Data LM Operational Amplifier Data Sheet, National Semiconductor Corp.
|Published (Last):||3 April 2014|
|PDF File Size:||4.18 Mb|
|ePub File Size:||9.82 Mb|
|Price:||Free* [*Free Regsitration Required]|
So the device is used for converting 8 bit parallel digital data input to analog signal output.
DAC Pinout, Features & Datasheet
The chip is designed with CMOS technology to achieve low power consumption and low output leakage current errors. The design also includes special circuitry that provides TTL logic input voltage level compatibility.
Double buffering of the device allows outputting a voltage corresponding to one digital word while holding the next digital word. This also dac0382 the simultaneous updating of any number of DACs.
DAC also designed with silicon-chromium R-2R resistor ladder network which divides the reference current and provides the circuit with excellent temperature tracking characteristics 0. DAC IC basically used in applications where an 8 bit digital data needed to be converted to analog value.
The device is specifically designed for it to be interfaced directly with the,Z80, and other popular microprocessors.
da0832 The device is available in the market for low cost and can be easily worked with. All these control pins need to be setup appropriately as mentioned above for successful DAC conversion of the device. Now for understanding the working let us consider the example application circuit given in the datasheet.
We can use the circuit to satasheet applications without worry as the circuit is tested working. DAC takes in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output. This analog signal is the current quantity that is directly proportional to the input datasheett value and this current parameter needed to be converted in to voltage parameter for further use. So to convert the current parameter in to voltage parameter we will use op-amp circuit as shown in circuit diagram.
This op-amp circuit is called current-to-voltage converter.
The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC datashset with DAC is achieved. Submitted by admin on 21 November Pin Configuration DAC is a twenty pin device and description for each pin is given below. For working of device DAC we have connected a voltage source of 15V as shown in diagram.
TL — Programmable Reference Voltage.